How do you Choose and care for wooden toys?
As parents and care-givers, we want two things from children’s toys: safety and durability.
Toymaking is a special pursuit where the utmost consideration must be given to the ultimate safety of the toy – not just the art and appeal of the woodworking.
One of the wonderful things about a wooden toy is its durability. A well-made toy can last for generations if given proper care.
First, we need to define “well-made”, on which toy safety depends. Then, caring for wooden toys is simple.
By following these guidelines from the toymakers at Family Tree Toys, your toys will remain strong and beautiful for your children’s children!
What You Should Know about Toymaking
WOOD VARIETIES
There are two types of wood: hardwood and softwood. Hardwood comes from deciduous trees (with leaves), and isn’t necessarily “hard”. Softwood comes from coniferous trees (with needles) and can be harder than soft hardwoods.
Common hardwoods used in toymaking: oak, alder, walnut, cherry, mahogany, birch
Common softwoods: pine, fir
Special considerations
CEDAR splinters can be toxic. If choosing toys made of cedar (*we wouldn’t, but if you do), maintain the toy to prevent splintering. Avoid cedar in baby toys and any toys that may be mouthed. OAK has a tannin that is better not ingested. Avoid oak in toys that may be mouthed. EXOTIC HARDWOODS might be toxic. There are many varieties — educate yourself, or make sure your toymaker is well educated on the properties of the wood being used.
WOODWORKING
When a toy is cut, attention must be given to the thickness of the parts as well as the direction of the grain (the lines that you see in the wood).
Pieces should be thick enough to resist breakage. How thick is “thick enough” depends on the variety of the wood. Our best advice – if it looks fragile, it probably is. Also, look at the grain of the wood in narrow pieces. It should run parallel with the length of the piece. Wood is weakest along short grain lines, or where stress is placed on the end grain.
ASSEMBLY
Toys can be assembled in a variety of ways – dowelled, screwed, glued and nailed. Each has its weaknesses.
We prefer DOWEL ASSEMBLY for the purity of wooden construction. This is achieved with glue and wooden “nails”. Changes in humidity can cause the wood to shrink and swell, loosening the dowels over time. This is particularly important where wheels are secured by a dowel axles. The toy owner should periodically check the assembly to make sure the parts are secure. If a part loosens, reglue with a non-toxic woodworker’s glue, according to manufacturer’s instructions.
SCREW ASSEMBLY is probably the most secure form of assembly when the screwed joints are also glued. Should the screws work themselves loose, they are sharp. The toy owner should periodically check the screws to make sure they remain tight. Ideally, the screws should be “countersunk” where the screw head lies below the surface of the wood. The screw can then be capped with a wooden plug (which gives the appearance of dowel assembly).Periodically check for loosened plugs.
GLUE ASSEMBLY can be remarkably strong when used in the right places. There are many considerations for the toymaker when gluing. The strongest use is when paired with dowels, screws or joinery such as grooves and notches. We don’t recommend using glue alone in joints that will be stressed. If a glue joint breaks repeatedly, it needs to be fortified with dowels or screws. 1/4 to mm